Build a Model Rotor Sailing Ship
This little model uses an unpowered modified rotor which also provides rotary shaft power to spin an underwater propeller. It's actually a Magnus windmill that will spin regardless of the wind direction.
Item # 10 - 6 - 4
Cost >>$2.00
S & H *** U.S.A. >> $2.00
|
More Info OR,
| |
Build a Delta Wing Jet Model
When provided with a 15-second fuel supply, the pilot model soared about 1500 ft. at an altitude of approximately 30 ft. then gently glided to earth.
Powered by a model jet engines - such as Jetex 100 or 2 Jetex 50's.
Item # 10 - 6 - 7
Cost >>$2.50
S & H *** U.S.A. >> $2.00
|
More Info OR,
| |
Build a Model Air Car
With a hollow whistling note audible over the whine of its tiny engine, this advanced working model of a ground-effect vehicle skims across the floor supported on a cushion of air.
Air is supplied by a prop to a peripheral slot which produces a high-speed wall of air around the edge of the model to retain the lift.
Item # 10 - 6 - 2
Cost >>$2.00
S & H *** U.S.A. >> $2.00
|
More Info OR,
|
|
Build a Replica 15th Century Wooden Wheel Clock
Only four wooden wheels, a rocker arm ( foliot escarpment ) instead of a pendulum, and full visibility of its operation, make this 15th century clock a fascinating conversation piece.
Item # 10 - 6 - 5
Cost >>$2.00
S & H *** U.S.A. >> $2.00
|
More Info OR,
|
|
Build a Radio-controlled Air Driven Model Hydroplane
From prop to servos, all the gear in this sleek air-driven hydroplane comes directly from the world of the radio-controlled airplane, reducing the maintenance and control problems.
Uses 6 channels ( you can get by with 4 ).
Regular model airplane propeller. Fuel tank holds 10 oz. - enough for a 10 minute run at low throttle with a KB-45.
Recommended for engine size 19 to 45.
Item # 10 - 6 - 8
Cost >>$2.50
S & H *** U.S.A. >> $2.00
|
More Info OR,
|
|
Two Airplane Models - Hoopskirt and Parasol
Hoopskirt has a 'Flying Barrel' design.
Parasol as a 'Pancake' wing design. Both are unusual but both perform very well
Item # 10 - 6 - 6
Cost >>$3.00
S & H *** U.S.A. >> $2.00
|
More Info OR,
|
|
Build a Spinning Wing Autogiro
This little model uses an unpowered modified rotor which also provides rotary shaft power to spin an underwater propeller. It's actually a Magnus windmill that will spin regardless of the wind direction.
Item # 10 - 6 - 3
Cost >>$3.00
S & H *** U.S.A. >> $2.00
|
More Info OR,
| |
Build a Pivot-Wing F-111
When provided with a 15-second fuel supply, the pilot model soared about 1500 ft. at an altitude of approximately 30 ft. then gently glided to earth.
Powered by a model jet engines - such as Jetex 100 or 2 Jetex 50's.
Item # 10 - 6 - 9
Cost >>$3.00
S & H *** U.S.A. >> $2.00
|
More Info OR,
| |
Paddlewheel Riverboat
It's small paddle wheel turns just like the 24 ft original, but instead of being driven by steam, it's powered by a rubberband. Complete even to the tiny steam pipes of the calliope
Three pages ( 2 sheets - front and back on first sheet - front on second sheet )
Item # 10 - 6 -10
Cost >>$2.00
S & H *** U.S.A. >> $2.00
|
More Info OR,
|
|
